GEO5 Abutment program is used to design bridge abutments including wing walls. It allows checking the abutment for overturning, translation, bearing capacity of foundation soil and dimensioning of dec...
This program is used for design of pile walls stabilizing slope movement or increasing safety factor of the slope. The first analysis should be done in the Slope Stability program, where the active an...
This program, based on the finite element method, can model and analyze a wide range of geotechnical tasks, including terrain settlement, sheet pile/diaphragm walls, slope stability, excavation analys...
The FEM - Consolidation is used to perform time dependent settlement analysis under foundations, embankments and surface loads (surcharges). Given the external load and the mechanical and hydraulic bo...
GEO 5 FEM - Tunnel is used to design and analyze tunnels. It includes specialized tools for the definition of tunnel lining, the system of anchors and rock bolts and grouting-strengthen regions. The r...
The FEM - Water Flow is used to perform steady state or transient water flow analysis.
Water Flow is an extension module of the FEM program for the analysis of general geotechnical problems.
The GEO5 Gabion program is used to verify the design of walls built from wired baskets filled with rock (gabions). It allows the analysis of arbitrary shapes including overhangs requiring anchoring.
Geoengineer.org uses third party cookies to improve our website and your experience when using it. To find out more about the cookies we use and how to delete them visit our Cookies page. Allow cookies
