Keller applied ground freezing in the largest infrastructure project ever conducted in Suffolk County, New York.
Keller is one of the few companies in North America to offer ground freezing technique application. It’s also the only one to carry out its own drilling for the refrigeration pipes and to run its own in-depth analysis and modeling to ensure the highest levels of quality control.
A 4.2-kilometer (2.6-mile) stretch of outfall pipe pumping millions of gallons of treated wastewater under the Great South Bay is being replaced. A $187 million construction contract was awarded by County officials in May 2018 to a joint venture of OHL, Posillico and SELI Overseas. Keller was handed the subcontract for temporary excavation support and groundwater control on the tunnel’s launching and receiving shafts.
The technique was used to provide excavation support and groundwater control on two shafts for the tunneling project. The 38-meter-deep, 10,5-meter internal diameter launch shaft specified ground freezing, in large part due to the amount of space available at the Bergen Point Wastewater Treatment Plant, where the tunnel starts. “It’s a small site, with room for just one rig, so there isn't really space to carry out a diaphragm wall,” Keller’s Director of Ground Freezing, Joe Sopko, mentioned.
A highly efficient design
The tunneling project required a 6-meter thick frozen bottom plug as a result of the permeable sands that are deposited at the bottom of the proposed launch shaft.
Thorough laboratory testing and modeling enabled Keller to create a highly efficient design, with the optimum number and spacing of refrigeration pipes. With such a large part of the cost going into the drilling, it was vital to get the specifications just right.
“Initial frozen soil compression tests provided to us reported lower-than-expected frozen soil strengths and didn’t take into consideration groundwater salinity. So we collected our own soil samples, subcontracted frozen lab tests, and used a time-dependent heat-transfer model to evaluate the time needed to freeze the perimeter and the bottom plug. This was coupled with a model that included groundwater flow to evaluate the effects on the formation of the frozen earth wall," Sopko, stated.
Striking a balance
49 pipes were installed into precisely drilled and aligned holes on 0.9-meter centers around the perimeter of the launch shaft, with nine in the middle, to depths of 45 meters. The pipes were then used to circulate a calcium chloride brine, chilled to -30ºC to an exact flow rate for six weeks.
According to Shawn Coughlin, Keller Senior Project Manager, the "sequencing was more complicated than a typical ground freezing project. The design was based on freezing the center and perimeter pipes simultaneously. Then, once the bottom was frozen to the right temperature, we removed the interior pipes to make excavation easier. The perimeter pipes were sufficient to maintain the freeze".
A team that’s second to none
Keller returned in November 2019 to work for the receiving shaft after completing the launch shaft in 2018.
This time, 39 pipes were installed around the perimeter with seven in the center. In addition, 24 pipes were installed in a grid pattern to freeze a break-in block for the tunnel boring machine. Freezing is now complete and overall, the project has been a significant success.
The decision on the construction of the Stoneheng...
Hubbell used helical piles for the installation o...
Bentley utilized PLAXIS 3D to accomplish a challe...
China is leaning towards utilizing wind and solar...
Keller will participate in a Miami project in whi...