Rock masses are characterized by the existence of distributed joints. The mechanical properties of jointed rock masses are strongly dependent on the properties and geometry of the joints. Jointed rock masses are usually weaker, and more deformable and are highly anisotropic when compared with intact rocks. Constitutive modeling of jointed rock masses has long been a subject of interest and numerous models have been developed in attempts to simulate their mechanical responses. There are two groups of these models: discrete models and continuum models as summarized by Cai and Horii (1993):
The Jointed Rock model was conceived and implemented as an anisotropic elastic-plastic material model which assumes that the behavior of the intact rock is linear elastic while that of the joints is elasto-plastic.
The application of the Jointed Rock model is justified for material that shows parallel joint sets or joint families, the spacing between which has to be small compared to the overall dimensions of the structure.
A companion constitutive model has also been developed as a user-defined soil model, namely the Jointed Rock model with overall Mohr-Coulomb failure criterion (Iso-JRMC). It is a combination of the native Jointed Rock model but with an isotropic elastic part (instead of orthotropic) and the Mohr-Coulomb model. Plasticity will still primarily occur in (up to) three stratification or fault directions (planes) using cohesion, friction angle, dilation angle, and tensile strength on each plane, while an overall MC criterion (based on principal stresses) will also be considered in all directions for the rock matrix. Because of this, it is possible that failure occurs along the sliding planes as well as in the intact rock, which is not possible for the standard Jointed Rock model.
The advantage of this model over the standard Jointed Rock model in PLAXIS is that the latter may lead to ”locking” if a potential failure mechanism requires other than the predefined failure directions to develop. The Iso-JRMC model will overcome the ”locking” issue since it may (eventually) fail in other directions as well (according to the overall Mohr-Coulomb criterion along the maximum shear direction that may be different than any of the pre-defined directions), such that a continuous failure mechanism may be obtained. This has been perfectly illustrated by Stelzer (2015) on the stability assessment of a rock slope.
Figure 3: Comparative simulation between JR and Iso-JRMC models (Seltzer. 2015).References
M. Cai and H. Horii (1993) - A constitutive model and FEM analysis of jointed rock masses, International Journal of Rock Mechanics and Mining Sciences & Geomechanics, Vol.30, Issue 4, pp. 351-359.
M. Stelzer (2015) - Numerical Studies on the PLAXIS Jointed Rock Model, Master Thesis, TU Graz.
Source: Introduction to the Jointed Rock Model for the Modeling of Soft Bedded Rock Formation
Learn more about rock engineering applications, their challenges, and the resources you can use to...
Rock engineering projects can be fascinating. Engineers working on rock need to design solutions th...
Rock engineering projects can be challenging. Engineers working on rock need to design solutions th...
In the webinar Bentley will showcase formulation and visualization of Jointed Rock model, extension...
Rock at depth is subjected to stresses resulting from the weight of the overlying strata and from l...
Rock mass is a matrix consisting of rock material and rock discontinuities. Its characterization...
The following was prepared by Dr. Ronald B.J. Brinkgreve, and first presented by Virtuosity. Numeri...
In the Introduction to this paper, many names are mentioned of those with African origins or associ...
Discover the capabilities of model tunnelling in rock with PLAXIS. With several models available fo...
Looking for more information? Fill in the form and we will contact Bentley for you. Alternatively, you can visit Bentley's website and speak with a Bentley Geotechnical Expert.