The International Information Center for Geotechnical Engineers

Computational Geomechanics

A new strength criterion for structured soils
E. Liu,Q. Nie,J. Zhang. (2013).
Creep model for unsaturated soils in sliding zone of Qianjiangping landslide
L. Zou,S. Wang,X. Lai. (2013).
Analytical solution of longitudinal behaviour of tunnel lining
F.J.M. Hoefsloot, . (2008).
Deformation and pore pressure model of the saturated silty clay around a subway tunnel
X. Zhang,Y.Q. Tang,Z.D. Cui. (2008).
Modelling and prediction for bored tunnels
E. Leca, . (1996).
Design and analysis of wall for deep excavations - A survey on Japanese literature
M. Ikeda,K. Kato. (1994).
Modeling of loads acting on shield
M. Sugimoto, . (1994).
A method for estimating squeezing earth pressures acting on a deep tunnel
S. Nishimura,H. Shimizu,R. Nakano. (1994).
Optimizing Hydraulic Fracturing Treatment Integrating Geomechanical Analysis and Reservoir Simulation for a Fractured Tight Gas Reservoir, Tarim Basin, China
F. Gui,K. Rahman,D. Moos,V. Vassilellis,C. Li,Q. Liu,F Zhang,Ji. Peng,X. Yuan,G. Zou. (2013).
An Efficient and Accurate Approach for Studying the Heat Extraction from Multiple Recharge and Discharge Wells
B. Wu,X. Zhang,A. Bunger,R. Jeffrey. (2013).
The Impact of the Near-Tip Logic on the Accuracy and Convergence Rate of Hydraulic Fracture Simulators Compared to Reference Solutions
B. Lecampion,A. Peirce,E. Detournay,X. Zhang,Z. Chen,An. Bunger,C. DetournayC,J. Napier,S. Abbas,D. Garagash,P. Cundall. (2013).
Testing and Review of Various Displacement Discontinuity Elements for LEFM Crack Problems
H. Jo,R. Hurt. (2013).
Three-Dimensional Numerical Model of Hydraulic Fracturing in Fractured Rock Masses
B. Damjanac,C. Detournay,P.A. Cundall, Varun. (2013).
Secondary Fractures and Their Potential Impacts on Hydraulic Fractures Efficiency
A.D. Taleghani,M. Ahmadi,J.E. Olson. (2013).
Stress Intensity Factor Determination for Three-Dimensional Crack Using the Displacement Discontinuity Method with Applications to Hydraulic Fracture Height Growth and Non-Planar Propagation Paths
F. Sheibani,O. Olson. (2013).
Numerical Simulation of Sequential and Simultaneous Hydraulic Fracturing
V. Sesetty,A. Ghassemi. (2013).
The Geomechanical Interaction of Multiple Hydraulic Fractures in Horizontal Wells
S-W Wong,M. Geilikman,G. Xu. (2013).
Modified Formulation, ε-Regularization and the Efficient Solution of Hydraulic Fracture Problems
A.M. Linkov,G. Mishuris. (2013).
Fluid-Driven Fracture in a Poroelastic Rock
Y. Kovalyshen,E. Detournay. (2013).
Modeling of Proppant Permeability and Inertial Factor for Fluid Flow Through Packed Columns
B.R. Meyer,L.W. Bazan,D. Walls. (2013).
Numerical Simulation of Hydraulic Fracturing in Heterogeneous Rock: The Effect of Perforation Angles and Bedding Plane on Hydraulic Fractures Evolutions
X. Men,C. Tang,S. Wang,Y. Li,Ta Yang,Ti Ma. (2013).
A Numerical Investigation of Fault Slip Triggered by Hydraulic Fracturing
N. Zangeneh,E. Eberhardt,R.M. Bustin. (2013).
Modelling of wave-induced non linear dynamic soil response in vertical breakwaters foundation
C. Oteo,de-la-P. Fuente,M.M. Stickle. (2013).
Characterization of Model Uncertainty in Immediate Settlement Calculations for Spread Footings on Clays
A.W. Stuedlein,A.W. Strahler. (2013).
Numerical simulation of the process of geothermal low-potential ground energy extraction in Perm region (Russia)
A. Zakharov,A. Ponomaryov. (2013).
Interpretation of mechanical behavior of cement-treated dredged soil based on soil skeleton structure
T. Sakai,M. Nakano. (2013).
Integrating Nonlinear Pile Behavior with Standard Structural Engineering Software
R.P. Ray,J. Szép. (2013).
A new tool for the automated travel time analyses of bender element tests
R. Viguera,V.A. Rinaldi,K. Snelling,Compte Le,S. Rees. (2013).
Numerical modeling of a soil-mixing column behavior and comparison with a full-size load test
Kouby Le,A. Guimond-Barrett,J.-F. Mosser,F. Pellet,A. Grzyb,S. Costa-d’Aguiar,F. Cuira. (2013).
A large deformation finite element analysis solution for modelling dense sand
D. White,Y Hu,X. Li. (2013).