The International Information Center for Geotechnical Engineers

Thursday, 05 October 2017 08:34

Standard triaxial system with analogue measurement

Standard triaxial System by Controls Group is the ideal basic solution for performing standard triaxial tests such as effective and total stress laboratories that don’t require digital measurement.

All the data acquisition and test management are made in manual mode Power supply is only required for air compressor and for triaxial load frame during failure stage.

A typical Standard triaxial system with analogue measurements has the below features:

  • Fully analogue data measurement using dial gauge, load ring, double burette and pore pressure transducer;
  • Pore pressure measuring with dedicated readout unit, ensuring a negligible change in volume of the circuit of the pore pressure, as required by the Standards;
  • Pressure system using air/water interface and triaxial panel with air pressure regulators;
  • Easily extended with dedicated accessories to perform additional tests such as permeability, unconfined, CBR, etc.;
  • Easily upgradable to digital measurement system.

You can see all the characteristics and find more information about the Standard triaxial System here.

Source: Controls Group

Read 258 times Last modified on Thursday, 05 October 2017 09:04

The Geoengineer.org News Center is being funded by our Annual Corporate Sponsors " (learn more):

The Geoengineer.org Corporate Sponsors: